|
3.1 |
Scope All changes and additions to the exterior
of your residence that are not detailed under Section II Changes to Property
That Do Not Require Prior Approval, must be submitted to the Architectural
Review Committee for approval prior to the start of work. This includes,
without limiting the foregoing, fences, decks, patios, gazebo, hot tubs, sports
courts, color changes, sun rooms, room additions, screened porches, bay window
additions, swimming pools, privacy screens, berms, pole mounted lights,
freestanding flag poles, sculptures and lawn decorations over 3 ft high.
Approval will be based on the assumption that owner has obtained all required
permits as applicable. |
|
3.5 |
- Informational Guidelines
- 3.5.1 General Information
- All structures constructed on any portion of the
Properties shall be designed by and built in accordance with the plans and
specifications of a licensed architect. The following information is provided
for guidance purposes only.
- 3.5.2 Decks, Patios & Gazebo
All
decks, patios and gazebos must be installed in the rear or side yards except
for entry decks and patios. The installation may not extend into the side and
rear setbacks nor into any screen planting easements. Owner must obtain
building permit if applicable. Patios must be a minimum of 3 feet from property
lines and not adversely affect groundwater drainage.
Deck post supports shall be a minimum of 42" below
grade. Decks more than 18" above grade should have railings. Railings generally
range in height from 36" to 42". Stairs cannot encroach into required setbacks.
Decks may be made of wolmanized lumber, cedar, vinyl wood grain embossed
products, or wood-plastic composite. Decks and railings may be finished
natural, stained a natural color, be painted white or be painted or stained to
match the exterior color of the house. Decks shall be entered from the first
floor level.
Detached gazebo can be screened or unscreened. Roofing
material should either match that on the existing house or be cedar shake.
Complete construction details must be submitted. Siding of knee walls, etc.
should be wolmanized or cedar siding. Flooring is similar to a deck floor or a
patio pad.
Homeowners requesting covered (roofed) decks and
patios must submit details on roof style, roof pitch, construction details, and
the roofing materials and color. In most cases, roofing materials should match
roof on existing house.
- 3.5.3 Fences
The maximum height fence
allowed is four and one half feet (4-1/2'). Height is measured from grade
(ground level) to the highest point of the fence not including posts. On a
case-by-case basis, on lots that back up to major roads or the perimeter of
Oakhurst, six-foot (6') fences along rear lot lines may be allowed upon
approval of the ARC.
Fence locations on corner lots, or lots that back up
to public sidewalks, may be further restricted due to side yard visibility
constraints, corner yard set back restrictions, house location on adjoining
property, and aesthetics. In general, the required minimum setback is 10 ft
from the public sidewalk in order to maintain the open décor of the
subdivision. If special circumstances exist, the ARC may approve less than the
10 ft requirement. Corner lots will be handled on a case-by-case basis.
Specific information on your corner lot may be requested prior to submittal of
a plan.
Except for approved small decorative fences, the front
yard areas forward of the front corners of the house may not be fenced.
All fences must be made of either planed cedar or
wolmanized lumber (earth tone color stained, unfinished, or painted white),
vinyl wood grain embossed (white, redwood or cedar colored), brick, stone,
wrought iron (white, black, brown/bronze) or aluminum fences meant to look like
wrought iron (white, black, brown/bronze).
Rounded, stockade type pickets and chain link fences
are not allowed. Rail fences, including split, rounded, and flat board are not
allowed. All fences must have vertical boards meeting the below spacing
requirements.
For board fences, the minimum vertical board width is
four inches (4") milled (3-1/2" actual) and the spacing width between boards on
picket style fences is three and one half inches (3-1/2") maximum. The finished
side must be facing out with the support posts and the horizontal boards on the
inside facing the property's residence.
Fences cannot be placed on screen planting easements.
Homeowner fences must be located only at the base of a landscape berm on the
house side of the berm. Fences may extend into utility easements at the owners
risk.
The fence must be placed so the outside face of the
fence is on or inside the property line. It is suggested the fence be placed
close to the property line to allow for connecting properties fences. If it is
desired to place the fence within the property line, then it must be placed a
minimum of 5 feet from the property line to provide an aesthetically pleasing
look and allow for lawn care between the fence and the property line.
If property is to be left outside the fence, such as
cutting across a rear corner to avoid utility boxes, then a gate or removable
section shall be included to allow access for lawn care of property outside the
fence without entering into neighboring properties.
- Information Needed with Submittal:
A plat of
survey, with your house footprint, indicating the exact location of the
proposed fence installation shall be included. Any existing easements, drainage
structures or drainage paths shall be included. Hand drawn sketches of lot
boundaries are not acceptable.
The complete details of the fence design including:
height in all areas, type of material, width and spacing of vertical boards,
style, placement and width of gates, color and finish of fence surfaces. A
catalog photo, suppliers drawing or picture of an actual fence showing the
style fence to be installed is required.
The height, style and color of existing fences on any
of the adjoining properties must be indicated on your submittal. Back to back
fencing along the property line is not allowed. Whenever possible, we encourage
the installation of similar style fences on adjoining lots.
- 3.5.4 Berms
New Berms and enlargement
of existing Berms require ARC approval. Modifications to Berms for the addition
of trees or shrubs require ARC approval.
- 3.5.5 Privacy Screens
A privacy screen
is a structure erected for the purpose of obscuring the view or blocking the
sun. It may offer protection from two sides only. It shall originate from the
rear of the house and may not extend into the side yard or rear lot set backs.
The maximum height is 6 ft from either ground level or deck floor level if
appropriate. It shall be no more than 30 linear feet and may not extend more
than 20 feet across the back of the residence.
- 3.5.6 Room Additions, Sun Rooms, Screened
Porches
All room additions, sunrooms, screened porches and gazebos that
attach to the existing structure must be treated as permanent construction and
must meet all the setback requirements for permanent construction. The room
addition should match as closely as possible and blend into the existing home
so the house does not appear "added on to." This can make room additions more
costly, but is essential to maintaining the high aesthetic quality of the
community. Construction details must be submitted showing all elevations of the
addition, the elevation of the house where the addition will be attached, and
how the addition will be attached.
Roof should be gabled with a roof pitch that matches
the existing gables on the house. A minimum 6/12 roof pitch is generally
required. In special cases where second story windows make a 6/12 pitch
impossible, a waiver could be granted for a 5/12 or 4/12 pitch. Roof pitches of
less than 4/12 present a cheap, aesthetically unacceptable appearance and are
subject to snow damage and drainage problems and are not allowed. Shed roof
styles are also discouraged because they are generally less attractive, low
pitched and have a "tacked on" appearance.
Roofing materials, siding materials, eves, soffits,
gutters, doors, windows, etc., must match the existing house in type, style and
color. If the house has 4" or 6" lap siding, the addition must have the same.
Eight inch lap siding on an addition to a 4" lap sided house is not acceptable,
even if painted the same color. Cedar sided, screened porch additions to
aluminum sided homes have been approved as long as siding width and color match
exactly.
Metal sided or roofed sunrooms are not allowed. Metal
sunrooms, modified with gabled roofs with 6/12 pitches and asphalt singles and
siding to match the existing home, may be acceptable.
- 3.5.7 Sprinkler Systems
In ground
sprinkler systems may be installed with ARC approval.
- 3.5.8 Storage Buildings
Free
standing storage buildings of a temporary or permanent nature are not allowed
in Oakhurst per CC&R Article XII, Section 12. Lean-to additions to the
residence are not allowed. Rooms added onto the residence for storage shall
meet the requirements of Section 3.5.6 for Room Additions.
Portable storage bins are allowed. They shall be no
taller than 4 feet high and shall only be placed on patios or decks located at
the rear of the house. They shall be screened by deck railings or bushes.
- 3.5.9 Swimming Pools
In-ground
Swimming Pools may be installed subject to ARC approval of location, fencing
and landscaping. A City of Aurora permit is required.
Above ground pools are NOT allowed based on the
provisions of CC&R Article XII, Section 12.
The installed pool must be in-ground with no poolside
structures exposed above grade. The installation must not adversely affect the
flow of storm water on surrounding properties.
The pool installation must include a three-foot wide
hard surface, such as concrete, surrounding the entire pool. The pumping unit
shall be located near the rear of the residence and shall be screened from
surrounding properties with landscaping. All landscaping must meet the Oakhurst
requirements stated in the Architectural Guidelines, Section 2.5.
The rear yard must be enclosed with fencing, per the
City of Aurora and Architectural Guidelines. A separate modification form must
be submitted for fencing.
It is the property owner's responsibility to ensure
that the water in the pool is not left stagnant or untreated so as to create a
health hazard or nuisance to the occupants or surrounding property owners. All
below grade utilities and other structures must be identified and must not be
adversely affected.
- 3.5.10 Hot Tubs
Hot tubs may only be
installed on your deck or patio and must be screened from view of neighboring
properties.
- 3.5.11 Exterior Changes and Color Selection
Guide
The color of the front elevation, the side elevation, (if
applicable in the case of brick fronted homes), the two houses on either side,
the home directly across the street and the two homes diagonally across the
street should be considered in making color choices. Side elevation colors may
also need to be considered when corner lots are involved. In small cul-de-sacs,
additional houses may also need to be considered since cul-de-sac lots appear
to be closer together.
Exterior siding color should not be the same as the
adjacent homes. However, homes may be similar in color if the brick on the
front elevations of the adjacent home(s) is significantly different in color.
Some exterior colors might also be allowed if the materials are very different
and will give a different appearance from the street. Examples: Cedar siding
next to a stucco home, a partial brick front or an all brick front.
Brick colors should not be exactly the same as the
adjacent homes. Similar colors could be allowed if the exterior siding on the
front elevation of the adjacent home(s) is significantly different. Other
things to consider on brick are the size of the brick and whether or not they
are frosted. Brick samples with at least 6 to 8 bricks to indicate the
variations in the bricks, may be requested.
Trim, gutters and downspout colors should be different
from the adjacent homes that must be considered. Similar colors, or even the
same color, could be allowed if the exterior siding, brick, garage door, etc.
colors are all significantly different.
Garage door colors should be different from the
adjacent homes that must be considered. Similar colors could be allowed if the
exterior siding, brick and trim colors are all significantly different. An
exception would be white garage doors, which are allowed on adjacent homes.
Front door and shutter colors should be different from
the adjacent homes that must be considered. Similar colors could be allowed if
the exterior siding, brick and garage door colors are all significantly
different. Roofing material colors may be the same as adjacent homes.
For sided houses, the siding boards must be installed
horizontally with a maximum exposed board width of 7 inches and a minimum of 4
inches. Any trim that may be installed must be similar to the existing trim and
be in compliance with the existing standard of the subdivision.
Modification Form submittals shall include existing
colors, new colors, details of other changes including new siding material,
exposed board width and confirmation that siding will be installed
horizontally.
- 3.5.12 Driveways
Concrete driveways
shall be of earth tone color. Borders can be added to driveways as long as the
border remains within the property lines and matches the design style of the
residence and landscaping. Changes in driveway material, other than allowed in
Section 2.2, require ARC approval. Submittal shall include a plat of survey
showing location dimensions, material description and color, and shall include
product literature.
- 3.5.13 Ponds/Fountains
Ponds and
fountains that involve excavation must be submitted for ARC approval. The
submittal shall include a plat of survey showing the location and shape of the
pond or fountain. Details of pond/fountain design must be provided including
description of design, lighting to be added and location of any exterior
mounted equipment. Lighting for ponds and fountains shall not point directly
toward other surrounding properties. The design must not create a noise
nuisance to surrounding properties. Stagnant water which could become a health
hazard shall not be allowed to collect.
- 3.5.14 Freestanding Flagpoles
Placement is allowed in landscaping or grass areas only. No mounting is
allowed on concrete areas, house, decks, etc. Flagpole placements shall be
within pre-established building setbacks as shown on the plat of survey. No
placements are allowed on easements. Flagpoles shall be located no closer than
15' from public sidewalks and no closer than 20' from curbs. Artificial
lighting must not shine toward any neighboring homes or be too bright to cause
a visual disturbance. Light bulbs must be recessed in holders so lighting only
illuminates the flags and flag pole.
Poles shall be a minimal 12' in height with a maximum
height of 20'. Total height of the pole shall not exceed the top roofline of
the house. Poles shall be permanently installed, non-painted aluminum only.
Toppers shall be of standard ball shape and made of brass. A maximum of two
flags (US and a military or US Patriotic flag) can be displayed at any
time.
Efforts should be made to minimize noise impact of
clips. Flagpoles shall be installed and maintained so as to not be a noise
nuisance to surrounding neighbors. Flagpoles shall be installed in a
professional manner in accordance with the Manufacturer's guidelines. Detailed
guidelines for displaying flags are provided in Section 2.11.
Freestanding flagpole installations shall be submitted
for ARC approval prior to installation. Submittal shall include a plat of
survey showing location in proximity to house, existing landscaping, sidewalks
and street. Details of design of flagpole including materials of construction
shall be provided. Manufacturer's literature would be helpful. Design and
location of lighting shall be included. The submittal shall include the number
and type of flags to be displayed.
|